73 valiant no spark from coil

Lowandslow said

So I think I found the or a problem spot it in the harness that the wire from the coil goes into I attached a pic I'm reading 12 volts on the side from the bulk head at the fire wall and when connected it reads 5.6-6 volts same as on the coil it's self

Click to expand...

I usually post this, but read this article. I'd say you are "in the zone." Don't forget what I told you. You could have ADDITIONAL bad connections, such as at the ignition switch connector.

Disconnecting and connecting connectors does not give you a picture of what is happening, however. You must check UNDER LOAD. When you disconnected the connector, you removed the load.

http://www.madelectrical.com/electricaltech/amp-gauges.shtml