Torque Boxes vs. Frame Connectors
So what was your solution? I used a butt load of that waxy grease that came with the kit and mine still made noise.
Yea I fell for that bit of BS too for awhile (till I got sick of the squeaks)
I found out that where they were actually squeaking was where the bushing contacts the K member and right there where the shoulder of the pivot pin is againts the K member, so I made a tool to get oil in there.
I took a 4 foot long section of 1/2 square tubing and flattened the end with a hammer.
Then used a four inch grinder to taper the flattened end to a point.
I then tap the flattened end in between the K member and the bushing so it opens a small gap between them and drip a few drops of 90wt oil on the tubing and let it run down ito the opening for 5 or 10 min.
The length of the tubing makes it really easy.
Next time I drive it, the squeaks are gone, and I have to redo it about every couple of months.
