Eddy RPM heads: Should I be concerned about this casting defect?

Looks like the mold was kinda screwed up there. I can't believe it passed inspection! Edelbrock is going down the drain. I actually considered going with a Chinese head. From what I've heard and what I read in the thread noted above, The Chinese heads are just as good as Eddy's. You'll need to do some machining anyways with either so I'd rather save the extra couple hundred and use it towards machining. If Eddy's were better quality and closer to a bolt on out of box part then I would spend the extra for American made.

It goes like this:

Box one is loaded with manure and has an American flag on it. Price - $1200
Box two is also loaded with manure but with "Made in China" stamped in it. Price - $700

That's the way it looks to me.