Harbor Freight - Gems and Junk

dont use press to press out swedged wheel studs! Cut them flush with drum or hub and then push them out or safer yet, grind head off back then press out whats left. You can get swedge cutters too, look like hole saws. if you press a swedged stud back through the hub, youll enlarge the knurled hole and nothing will fit right.
I pressed a 360 pin into a cold rod and it took 16000 lbs on the gauge! It was on a 40 Ton beast with a high and low pressure settings. I was waiting for the rod to split but it never did. My machine shop couldnt heat the rod enough to slide it in properly. Are magnum rods any different on the little end besides being thinner???