Power terminal question

crackedback said
Find something like this. They come in red and black.

http://www.waytekwire.com/item/23508/BATTERY-BOOT-18-10-GA-BLACK/

With most any circuit make sure there is some form protection present.

Thanks for that link, That would for sure work

inkjunkie said
Look around a bit and you find all sorts of interesting things that may work....

http://www.delcity.net/store/6-Way-Bus-Bar/p_801497

and as to the circuit protection question, I have always just fused the relay power feed wire...

Thanks for this link, that is a good idea also!

RedFish said
My power source is the BATT' stud on the alternator My relays are in a enclosure on the right inner fender too, nearly opposite yours. You could run a wire from to though.
Under dash electrical is all the "difficult to service" I need. Under the battery and battery tray are about the last place I would add anything.

You have my thinking now, but I like the fact that they are "hidden" and they are easily accessible from under the car. But this is still a option to move them so I will look into this further.

skykeith said
I use wing nut terminals on the battery and run a large power cable to a power fuse module (Waytek P/N 46096). It has 2 fused outputs that are then routed to the relays for the main power. This is one I'm currently building using an old avionics "black box" rack for a mount.

Thats a nice set up, I'll check out that P/N you gave me.

Thanks everyone!