Egads, no power.....

My wiring under the bonnet is 90% done...the only hurdle now is to figure out what wires to cut and join because I bought a internally ballasted coil so I wouldn't have to deal with the ballast anymore..

Any hints on this wire surgery would be gratefully appreciated...

Installed my new instrument cluster. Left the light switch and wiper switch intact so I only removed the original gauges out of the equation...

Tonight I went out to find a switched power supply with my circuit tester and to find which colour wire I need to tap into to run a wire from the dome light wire in the left, rear of the car.

So I moved the key to the accessory mode and turned the dome light on..nothing...so I moved the key to "on" w/o engaging the starter..nothing..so I tried to spin the starter..nothing. Wipers wouldn't work either...

The battery is new.

The only connection in the engine bay that i didn't connect was the "Dash and instrument panel connection" which I couldn't find a mate to the odd shaped connection. I also didn't think it was necessary because I replaced most of everything and had kept the two major controls...

What am I missing ?

Thanks, as always..