1966 Dodge Dart

Been a while since I updated the post and I havent been making a lot of time to get out and work on the Dart but heres whats been happening. Ive removed the side 270 trim and have started to weld all the holes shut where it was attached. I've drilled the rear quarters so I can put the GT DART emblems on the back. The engine compartment is going to be getting all the holes welded shut that held the harness and battery tray in place. I have installed the mounts and brackets for the console and shifter then mounted both. I am in the process of fabricating seat brackets for the new seats. I still need to make the supports for on the floor to support the seat brackets. I am hoping to have both the seats in place so I can start on installing the rollbar and have that completed some time before the middle of june. I will be picking up the 904 transmission this week and I have started to push the engine builder to have the engine done by the end of may. I know as summer approaches my time will be very limited. I am shooting for completion by May 2015.
Here are some new pics
View attachment DSCN2487.jpg

View attachment DSCN2490.jpg

View attachment DSCN2494.jpg

View attachment DSCN2495.jpg

View attachment DSCN2427.jpg