Parts on the way!

mellow_utah said
Krazykuda, did you notice a difference when you rebuilt the front end? The headmans are long tube but they said they would work. There were a couple other brands they had listed as compatable. I hope they're correct I'll be annoyed if they're wrong and I have to send it back.

Difference in what?

We have the new suspension components in, new 1.000" torsion bars, and new KH disc brakes. We have to install the front sway bar still.

Right now we are working on the rear suspension and axle. We had a broken tap in the rear spring hanger mount that we just got out yesterday. Now we need to see if we need to helicoil or not. And build up the axle (brake lines, brakes) and get it ready to install.

Then we can finally get it down on wheels. :violent1:

Then do the sway bars (front and rear).

Then we have to install the dash board and finish installing the new wiring harness.

Then we can install the engine and trans and see how it sits..... :banghead:

We are going to run 68-70 stock 340 exhaust manifolds, so I can't tell you how the headers will go in. (not to mention our engine is not in yet either).

I can't tell you how it is yet, as we haven't put the tires on it yet as we are not done with it...

Here's with no suspension:

View attachment Rt Side Ft B.jpg

The 8 3/4 axle 3.91 sure grip:

View attachment Axle y Sway Bars B2.jpg

91 360 roller cam engine (disguised as a 70's vintage small block):

View attachment Ken 360 042514 A03 B.jpg

Same as first shot above, but with new disc brakes on:

View attachment Rt Side A02 B.jpg

Close up of disc:

View attachment Rt Disc B.jpg