zkx14 said

Anyplace the poly touches metal. (Unless they specifically say not to, don't recall if any exceptions) Use the 'super goo' grease in the kit , not regular bearing grease.

Click to expand...

krazykuda said

The ends of the torsion bars need to be greased.

Click to expand...

68er said

only issue we had was the upper control arm bolts.. the nuts flew off right away however the bolts were not moving under the gun. We pushed the control arm up as high as we could get it and soaked the bolts good. Overnight soaking and a few hard taps seemed to budge the rust in the bolt shaft enough the gun finally spun them out.

The rest of the install went fine with no hiccups.

The kit was complete and fit like a charm....

Next up is alignment with an old school mechanic... :cheers:

Click to expand...