Wiped a Cam Lobe. Total rebuild??

Looking for general opinions here. I have a 340 that was completely rebuilt about 14 years ago however the car sat in storage for 12 of those years and the engine probably only has about 500 miles at most.

I got the engine back out towards the end of last year and got it going again. Runs strong sounded great. A couple months after getting it going again and dropping it in my Duster, a Lifter failed and wiped a lobe off the cam.

Pulled the engine, Tore it down. A good bit of sparkle in the oil from the wiped lobe. Now I have torn down to block and rotating assembly. Everything looks good. Trying to decide if I just clean it out, replace oil pump and pick-up and reassemble with the new cam, lifters (Will be installing new heads and intake as well since I have them).. or go ahead and pull the rotating assembly to re-ring and replace all bearings?

What would you do?