Strut Rod Bushing???

I just did this job and used poly's. I think they were cheap. They came with 4 bushings and 2 sleeves. They are from energy suspension part number 5.7109G and you have the flat side towards the crossmember and the half moon side towards the outer washers. [(|--|)] Hope that makes sense lol. You prob already have the lca bushing part number- but here it is K791. I put these on my 74 duster and I just did this job the last 2 days. Definitely want to take apart at lower ball joint. I just took my calipers off the discs but messed up and hooked up both upper and lower ball joints and waited till last to hook up calipers-normal thinking right?? That's what I thought till my dumb arss had to take the brake hose off the calipers to route it behind the spindle area lol.
Good luck! Definitely need a press to install the pivot pins into the lca bushings. You can however-in a pinch- get away with installing the bushings with a big socket and a 2.5 lb hand sledge hammer. Press works better though lol. I did cheat and used the nut on the pivot-unscrew till face of nut is level with end of pivot pin- use good weighted hammer-small sledge- and "tap" the pivot pin to move lca back. hat this does is help push the torsion bar back out of its hole.