How do you successfully install intake/exhaust gasket?

If you got it to seal, it may be right. What is making noise?? I used the instructions on slantsix.org. Be sure to torque from center out. Don't have a better picture, but will attempt some clarification. Bottom triangles are inverted relative to top ones. i.e. They point up. You probably have three round ones for the center- one on top and 2 underneath. Newer ones like my 75 are all triangle except top center ( and special ones on ends). The flat spots will contact the flange areas on the manifold. There is no easy way, but there are more difficult ones...You can guide them onto the studs by puting them on a long rod or thin screwdriver. Touch the end of the rod to the stud and use something else to carefully slide the washer off the rod and onto the stud. Put nut in socket on an extension and start it. Once you have slight pressure on the washers you can use a long screwdriver to orient them, but they should be close on bottom because the heavy part is the long bottom side