I'll try what you say but another half inch? I'm only lacking .060 on the left side, where end play is .070. The right side adjusted fine with the adjuster nut, although it didn't seem to be pushing against the left axle.
OK, the right side adjusts both sides. Look at your bearing/axle retainers, when you put the bolts in did they have to pull it in or did they seat well against the housing/backing plate and you just tightened the nuts?
If you are saying when you push on one axle and the other doesn't move, it shouldn't. The end play is so fine your going to have a hard time detecting any movement.
Now, if you have excessive movement on one axle, then something isn't 100% seated.
When seated properly both axles will be in contact with the thrust buttons in the suregrip.
