Dampner out of wack

# 2 Parts truck :

Spent a bit this A.M modifying a bar to fit the TDC tool, dropped screw of TDC tool down in the cylinder as far as it would go, made my mark, rotated engine opposite direction as far as it would go, made another mark.

Cut out a narrow strip of paper, cut it to length so that it was between the two marks I had made and then folded it in half and marked center.

The dampener here as slipped a whisper. The center mark of the paper falls onto the leading edge ( ATDC ) of the notch that is on the dampener.

I would say this is acceptable and nothing to give a second thought too. Does everyone agree?