Indy 360-1 Cylinder Heads

360tripleblack7 said
Hello Guys,

I'm thinking in buy a Indy 360-1 K1 upper end kit from Hughes Engines.:finga:

http://www.hughesengines.com/Index/...nVt&searchmode=partnumber&page=2&partid=23690

This heads have a rectangular port design... So my concern is about if I can keep my current TTI exhaust 1 5/8 step 1 3/4 with stock port design and if will works good with these heads...

Bolt pattern is ok, but looking for the Headers and heads I can see some differences in the port design... This is my concern!

I'm using this TTI:

http://www.hughesengines.com/Index/...aGF1c3Q=&level2=NjctNzYgQS1Cb2R5&partid=23830

Thanks...

Those heads ootb only flow 260's cfm! They will need port work to run hard. Be very careful who you buy heads from and make sure you ask a lot of questions...when I sell the Indy -1 or -2 head I usually use their cnc intake port (230 or 245) and hand port the exhaust port and chamber...makes great power and I stay away from water!
I also use the Victor intake a lot to keep it under a flat hood.
Brian