How to Repair a Couple of Wiring Harness Problems

1969VADart said
Given the situation with my car, the ammeter bypass referenced in the article above may not be in the cards immediately. But I certainly appreciate the heads up and information. I have a new bulkhead connector from a previous project so I may disassemble this one and swap all of the wiring over inspecting each one as I go. I also have some new connectors.

Are you saying you have a brand new Bulkhead connector or a new "used" connector from another project?

If it's the later then be sure to make confirm each terminal fits snugly and securely into the used bulkhead. When I replaced the Bulkhead connector in my car I went with a new unit just to make sure there were no issues.

I also replaced the wire in the harness between the bulkhead and the connnector for the ignition switch.

I went through a dash harness repair few months back.
http://www.forabodiesonly.com/mopar/showpost.php?p=1970195180&postcount=39

After all of that, I'm now considering a Ron Frances Kit for the whole car and Crackedbacks headlight relay setup lol

AlV