1967 Cuda Notch 273 w/904

Through some great FABO posts (Mad Dart's Rebuild Recipe), I figured out what parts I really needed for a stock/slight HD application. I plan on rebuilding the 273 bored .030" over with a better crank etc. I wanted to make sure the 904 was good to go. This is what I ended up with:

ATSG 904 Manual
(Summit) TransGo TF-1 Reprogram Kit
TCS Billet Strut
TCS Pump Gears
TCS 24 Spring
Oregon Front Band
Oregon Rear Band
Oregon Rear Servo
Oregon HP Rebuild Kit (5 frictions/steels for front drum)
(Ebay) Springs and Bearings for overrunning clutch
(Ebay) Universal Spring Compressor
Assembly Lube

I also got a new set of snap ring pliers from Klipex. They are awesome..and a bit of overkill but I'm sure I'll get some great use out of them.