Lets see- RUST "B" GONE- Projects
Plus im doing the lower quarters and drop extensions as well I forgot to mention that in the previous posts.
Aaron
so you doing basically this
but not the over the axle hump... brace the frame rails if you take the trunk and tail panel off at one time or it might twist. the only thing that holds it all in alignment really is the tail panel and bumper panel pieces (or at least the 63-66 does)
Outer skin on and not attached to the inner drop.
View attachment DSCF2477.jpg
how bad the rust was
View attachment DSCF2468.jpg
here's mine with the over the axle hump in position checking for square. (it wasn't)
View attachment DSCF1960.jpg
here is what came out and the reason it wasn't square.
View attachment 036.jpg
the old over the axle hump, or what's left of it. bad pic but it was really bad
View attachment 046.jpg
yup it was that rusty.
View attachment 056.jpg
firewall to tail panel. the frames were welded to the body cart since I didn't want it to shift after I removed the floorpan. luckily the rocker panels in the convertible helped me keep it square.
View attachment 051.jpg
poped these out and repaired them since the ones I bought off of ebay wire full pieces but so crusty that ir was easier to fix these than try to save the ones I bought.
View attachment 057.jpg
here she is flipped over and me finishing up the welding after I squared itr up 1/4 inch off from the factory!
View attachment 2011_1109workcar0004.jpg
total floor done 66 trunk pan, 66 front floor pans and 73-6 rear floor pans to a 66 4door over the axle hump and then deadener put in.
View attachment DSCF3019.jpg
