I'll continue my threat.
Finally I started installing the slave cylinder and have some questions about that.
I sent a e-mail to them but haven't receved any answere.
I'll copy my message here and maybe you can help me:
I read the instruction and came up with 2 different versions.
First one:
I installed the bracket to the fist and the second hole on the trans.
After I installed the slave cylinder I noticed that it doesn't fit that well. Is seems that it's on a bad angle.
Here are the pictures:
Also, in the manual it said that I need to connect the slave to the clutch fork using spacers and a rubber/steel bushing (there wasn't in the kit and there wasn't on on the clutch fork before also).
In this picture you can see what I mean under the 1,2 and 3 hole. Also you can see that the 1. hole is a bit higher than the 2 and 3 hole. I think that this is the reason, the first setup is a bit bad and will rub. https://dl.dropboxusercontent.com/u/19022509/a883Trans.jpg
So if anyone has some pictures of their setup, pleas post some pic's.
