whats the deal with the new tranny mts.

I have been there with this, recently. I don't what the deal is either. I ran the bolt through the mount, to the crossmember. I then bolted the mount to the trans, then I put the jack under the crossmember and forced it up in there as a unit. it was a *****, I didn't like it. I then took everything back apart, mind you, I was using the mount on the LEFT. I took my cut off wheel and cut into the slot all the way out the back. I put it all back together with some BF washers. it fits like a glove now. I could have taken my welder and filled the slot up the where it the bolt goes, but I didn't. I needed my **** together, and I am not worried about it because the rubber in the mount takes all the twisting any way