727 trans cooler lines

I added a external cooler as well as used my radiator cooler on my car. Here is what I bought.

(4) 1/8" npt to -6AN
(4) -6AN Straight
(1) -6AN 45* Elbow
(1) -6AN 90* Elbow


I installed the 1/8" npt to -6 AN fittings. (2) in the trans and (2) in the radiator. Then out of those at the trans end I used a (1) -6AN Straight in the rear and a (1) -6AN 45* elbow at the front of the trans. I wasnt comfortable how close it came to the headers using a straight and the 90* elbow hit the bell housing.

At the radiator end I used a (1) -6AN Straight on the drivers side. This was my input from the trans. On the passengers side I used (1) -6AN 90* elbow and directed it towards the drivers fender where I had some holes already drilled for my lines and swept it thru the core support to the external cooler. Where I installed (2) of the -6AN straight fittings on the external cooler. Then ran the return line back thru the core support back to the trans.

I also bought 20' of the PTFE braided line instead of the rubber line. In my opinion it was harder to work with, but is suppose to hold up better. I probably have about 7' left over.