How to refurbish a bulkhead connector?

I agree that when it comes to electrical you don't want to be thrifty when repairing primary areas on the old systems. Check out my repair thread:

http://www.forabodiesonly.com/mopar/showpost.php?p=1970195180&postcount=39

I was originally going to source a bulkhead connector from a donor harness but ultimately decided to go with a new connector from Evans. Mostly because the used bulkhead gets worn and heat cycled which can prevent the tang on the terminal connectors from getting a good positive lock when inserted into the bulkhead connector. This aspect is very important when you start plugging in the engine harness connectors and want to make sure you have positive insertion.

Pick up a little dielectric grease also.

Best advice is to take your time and inspect everything.

AlV