1968 SS Dart in progress

Just washed her up today. Still 100+ degrees her in sunny Arizona so I have taken hiatus of any major work since last post. Seats are now installed and look great, 440 block is back from Chuck's speed center after all machining and balancing and I completed all deburring! Nasty casting flash! It will be sent back to have .020 shaved off the deck based on piston to deck height measurements and then clean up and assembly of the short block may begin. I will post pictures as the build progresses. I purchased a good used set of TTI long tubes off ebay about a month back for under $350.00 shipped. Some minor repair on a couple the 2" primaries and fresh ceramic coating and they will be as good as new! I cannot wait for the weather to get better soon and finish up wiring the MSD, battery cables, etc...