74 Dart Sport Restoration

On the right side I replaced the entire panel. I just drilled out the spot welds around the panel with a spot weld cutter and removed the complete panel.
Don't forget while your are doing this it is a great time to seal and repair any problems to the inside of fender.

Over lap your panel at the top under the window, again I used 1/2 and offset the edge. The rear of the panel is factory stamped to fit inside the trunk lip and around the tail ligjht panel.

Do not force the panel to fit because you will dimple or dent it. If the replacement panel doesn't fit right around the wheel well lip, or at the rear edge of the door, or down around the rocker panel, fix it by adding or removing metal. If that panel is really bad send it back where it came from.