360 timing

I tend to set my 360 at idle using a vacuum gage (and smoothest idle) to get the best reading , then check it at full advance. I have 268 MP cam and it runs best at about 15 Deg initial , and all in at 3000 rpm it reads 34 deg total timing which is probably as high as I wish to go.
I use timing tape to read the total timing, or use a dial back timing light

I use adjustable rocker arms, and set my preload on the hydraulic lifters around .020/.025 thou or so, but with the factory rocker arms and proper length pushrods the preload should be set when the rail is bolted down

a little bit of 2 cents, not that I know a lot...... learning myself with a lot of help from fabo members