SS/B Barracuda project

SSing said
Thank You... But I will as fare as possibly stick to my game plan. Witch is build as close to as the Hurst cars came, with the additional modifications done by the racers, where it was done during the first couple of years.
I will use Hooker, it worked the first time, with just the sheet metal flattened. Than again I did not use the spacer... Maybe you are right... we will see... I cover it up with epoxy, and forget about it for the time being...

I think if you look at some early pics of factory cars and pics in the Schield book the factory got that center section beat back too. They must have had an even bigger hammer.

Pic of original car here: http://board.moparts.org/ubbthreads/showflat.php?Number=6410500

This is the car that barely got the valve covers to fit with almost the same panel beating as you did.

[ame="https://www.youtube.com/watch?v=TDUcTidxlpg"]1968 Super Stock Hemi Dart from Hurst Walk Around - YouTube[/ame]

Same car, this was what Troy did and it was really too close for comfort: