Bring my 73 dart swinger back to life.

Changing bearing / bushing in the column. Never did this before. It was a little nasty in there.

#1 cleaned it out with WD-40 and removed the shaft.
The turn signal switch looks good. BUT, I'm going to change it anyway.

#2I would like some feedback from somebody who has disassembled the key section to change out the bottom bushing. Was it difficult lining up the shift gear on the top with the arm down below?? Got any tips before I start?

#3 The bearing came out easy except once i removed the retainer clip.

#4 Is the bottom bushing and seal

#5 There is a little wiggle in the steering lock. Is the supposed to be like that? Doesn't spin just wiggle.

:coffee2: