75 dart v-8 4 speed
[/IMG]
[/IMG]
[/IMG]
[/IMG]
[/IMG]
[/IMG]
[/IMG]
Yes it has a 73-74 grille...
Car has faded some since the top shot was taken and has plenty of scratches and rock chips etc. I will post more pics but this pic is very flattering.
I am needing funds for an RB stroker and something has to go...
Clear Texas title and very good tires
Non A/C car with a new heater core
Sport tail panel
Factory high back cloth buckets
Power steering
Engine is a 318 bored 0.040 with headers
full length exhaust with h pipe and glass packs
4 on 5 1/2 all the way around with manual front disk and 14" Rallyes
Weiand dual plane small port matched to heads with edelbrock 625 cfm electric choke
cam is a 292/455 hyd
heads are mildly ported 302 swirl ports with bronze guides and 11/32 long stem SBC valves.
Over $800 in the heads not counting porting and castings
8.25 rear axle with 3.55 posi
A-833 OD aluminum case trans with hydraulic clutch conversion
Tranny leaks a little, I will include seal kit
I have repaired some previous body work but it needs lower rear quarter patch panels.
Asking $5000 OBO
Yes it has a 73-74 grille...
Car has faded some since the top shot was taken and has plenty of scratches and rock chips etc. I will post more pics but this pic is very flattering.
I am needing funds for an RB stroker and something has to go...
Clear Texas title and very good tires
Non A/C car with a new heater core
Sport tail panel
Factory high back cloth buckets
Power steering
Engine is a 318 bored 0.040 with headers
full length exhaust with h pipe and glass packs
4 on 5 1/2 all the way around with manual front disk and 14" Rallyes
Weiand dual plane small port matched to heads with edelbrock 625 cfm electric choke
cam is a 292/455 hyd
heads are mildly ported 302 swirl ports with bronze guides and 11/32 long stem SBC valves.
Over $800 in the heads not counting porting and castings
8.25 rear axle with 3.55 posi
A-833 OD aluminum case trans with hydraulic clutch conversion
Tranny leaks a little, I will include seal kit
I have repaired some previous body work but it needs lower rear quarter patch panels.
Asking $5000 OBO
