Our Stroker Build - Looking for comments good or bad!!

So just a small update on the Cam.

I never got any response back from Bullet Cams.

I let the builder, Competition Automotive, source the cam and they talked to Comp. When it comes down to it they decided to use the same cam that was in the 440. Its the Comp 23-770-9 which is .690 Lift and 287 duration @ .050. I figured the RPM range was a bit high being its spec'd at 5000 to 7200. Competition thinks that the lower compression ratio (11:1) will reduce the high end range and work well. We will probably trap around 6500...

This cam was in the 60 over 440 and seemed to work well. I was reluctant to go to a cam with less lift then we had. In actual fact maybe the 440 was a little over cammed.

Time will tell. They are waiting on the pistons to do the final decking.

Has anyone have any issue with fitting a stock pan to a 4.25" stroke crank? Our pan is a stock rear sump which we have extended. I'm also wondering is a regular windage tray will work with that crank or do I need something different.. Thanks