tti header clearance problem

was able to work on this problem, did as Sam at TTI stated to loosen all the nuts on both motor mounts and realign the engine on the driver side, I loosed them and use a come a long and pulled back on the driver side on engine it looked good with nice gap about 1/4 tighten the mounts up took off the come a long and gap closed up a bit but is about 2 times what it was before but I think it is still tight, I spoke with a buddy he states to take a socket and use a big c-clamp to but a nice dimple in tube not a dent I think I will do that just to give me a little more wiggle room