1.00 ff tb

I'm working on a 69' Dart and have a problem/question(s). I have a QA1 k frame, lower control arms and adjustable strut rods. The upper control arms are from Firm Feel along with their 1.00 torsion bars.

I set the engine in and installed the tb. Set the car back on the ground and the car is sky high! So I take all apart, double check everything and try again. Same problem, and the tb hex tab is sitting on the adjuster nut, bolt is out. So wtf am I doing wrong?

Just for sh1ts and giggles, I put a board across the inner fenders and put 5 50# bags of sand to simulate all the sheet metal, fluids, bumper etc., and it dropped a tad bit.

So anyone have any idea of what's going on? I checked the tb and the are installed correctly, and they have the offset twist to them......just can't figure this one out!!