Snow Ball #2 - 72 Swinger

finished making the front spring mounts
the frame connectors, will be welded into the front of the mounts




passenger side





drivers side



the largest hole is for the emergency brake cable to pass thru

then the cable end mount will be re-welded/ positioned on the side of both the inner front mounts



a small C-section will be removed from the frame rail
for the front spring eye to set up into

then will have access to the locating pins
to weld them inside/ outside the frame rails

install the front mounts/ weld in place

last is box in the c-section and end on frame connector

Right height will be +1"



cut two 3"+ spacers out of a cummins drive shaft ( was saving for the yoke)

Turned them on the lathe to 3"
then cut out 3/4 of it
to be used to box in the C-section