New tie rods don't fit the drag link holes?????

Once again, HELP!!!

I'm redoing the front end on my 69 Dart project and have hit a small snag. Using MOOG Part # ES319R and ES319L inner tie rod ends...

The "shoulder" of the tie rod stud, (below the threads) will NOT fit in the hole in the drag link. I see they are tapered holes...and yes they fit in the larger opening but obviously that would put the drag link upside down.

**Just compared the old TR ends and they are, in fact, smaller than the MOOG replacements. GRRRRRRRRRRRRRRRR....

Any one ever experience this with aftermarket TR ends and your solution??

Thanks AGAIN...in advance.