Left for Dead 68 Barracuda Buildup

I went ahead and cut the steering box pad off the K-frame.
I want to move the manual box as close to the frame rail as
I have room for. Turns out the lower control arm pivot and
sector is the limiting interference. It took some careful cutting and grinding on the steering box mounting pad to get the box moved closer to the frame rail. I was paying close attention to get box repositioned at the correct height and front to rear as where it had mounted originally. Only changing the side to side location.
I took a picture of the tight spot and how steering column lines up with box moved 3/4" closer to the frame rail.
As you can see this is the most it can be moved. It just touches.
A couple aditional metal gussets will be welded in to strengthen the steering box mount after engine mounting pads are built and welded on. I had to cut a good portion of the strength out to move it over and make room for driver side engine mounting pad.
Time to make some Hemi mounts.