splash sheilds before and after
Looks like they should work fine. Fiberglass?
I took galvanized tin cut to the shapes I needed then a bit of hammer and dolly work
and then pop riveted the pieces in place then flatened the rivets with the hammer
and dolly and anvil when possible, then I went over the patches with kitty hair
(fiber glass) then a few hits with the grinder to smooth it out and then blasted them with
spray on rubber under coating. The reason for using pop rivets was the the rusty metal
was just burning away when I tried to put real metal patches in. Bonus is the galvanized
tin and aluminum rivets will never rust. Thanks for the compliments and comments folks.
Cheers.
