Post your 10 second combo

I've had 3 engines in my car and have been 10's or very close with all of them.
The car is a all steel 73 duster that weighs about 2900 without driver. It has roll bar with bolt in frame ties. Stock front and cal track rear suspension with their shocks.

The first engine was a stock stroke 360 that make about 450 hp with factory crank and rods with KB 191 pistons. It had ported 974 heads with 2.02 valves and Harland sharp 1.6 rockers. A mp 528 purple shaft and a victor intake with a 950 HP and 1 7/8 hedman hedders.
It went the best of 11.04@122 just before it blew up. I hydro locked it the week before and didn't realize it bent a rod.

The second motor was a 416 stroker that made 500 hp with cast crank, H beams and weisco -20 pistons. It had a can motion can [email protected] with 600 lift and the same top end. Both of the above motors used a 9 1/2 in continental convertor flashing around 4200 and 4.56 gears. This motor went a best of 10.43@127.

The 3rd motor was a buddies we put in with his transmission so I don't know everything about it. It is a Indy headed 416 that made 643 HP. It had a 635 lift cam with a 1000hp carb. I don't know which heads they are I think the bigger ones, the -2 ?? I think they flowed in the 320 range. A fought motor.
It went 9.84@136 without really tuning it. We just dropped it in and went racing.

I am in the process of building another 416 motor with the top end off Brian's @IMM Engines motor he built for an article for Hot Rod that made 621 hp. This motor should be pretty good too.