Drum to Disc on Early A Body Problem

If the turning radius is only 1 3/4 then I will be good with just grinding a small amount of clearance. In the last photo you see that the lower ball joint assembly is within a 1/8" from touching the stop on the lower control arm. Glad to hear someone else has run into this. I hate when no one else has ever had the same issue because you know that means something is drastically wrong and you are going to have to open your wallet again! As for the calipers I am fairly certain they should go on the back side on this application.
Thanks, Rod

I noticed after posting that the word calipers was underlined. Didnt want to offend you so I thought I would tell you it did that on its own. I notice that often when posting.