Rocker arm wear pattern

So i was mocking up my rocker gear on my 360 and was looking at the wear on the valve tips to check the geometry.

I have an la 360, so it has a shaft rocker system, and I am running comp ultra pro magnum rocker arms. I noticed that the pattern is biased towards the exhaust. It looks closer in the picture, but I have about ~90 thou till the end of the valve, so its not going to roll off, but I still would think it would be better to have it centered, especially since I am running a solid roller cam.

I would think that lash caps would help, and I should have room for them, I just got pushrods, but I have some adjustment to still use them and lash caps. Is this wear pattern bad? or should I check again with the lash caps?