Gear selecter seal

There are 2 seals there to be replaced,, the inner kickdown shaft and the outter shift lever..

Yes they can be changed with the trans in,, but will need the valve body removed for an easy replacement...

With the v/body out, you can tap the case seal out from below,.. and I usually chamfer the new seal to aid installation, use a little "permatex" around the outer edge , then use a small slide hammer up thru the hole,, then the seal, an appropriate size washer and nut,, then use the slide hammer to gently tap/pull the seal back down into the case..


The inner kick-down seal needs the circlip and washer removed,, then a small tool to pry the seal out,, noting direction of lip,, reverse to install,,

hope it helps