rear window removal 64-66 barracuda

So I think you have a 64 from your name. Which is the same year I have and I have actually done this. First thing you must do is remove the rear chrome band, you do this from the cargo area, there are 4 nuts that must be removed, and slowly pry that off, taking the trunk hinge covers off will help you out.

Ok so now take the lock strip out, there are 2 pieces if its factory and not been done before, and 2 corner pieces, save the corner pieces and lock strip. At least the corners!!

Now you will need to get a non-marring chisel set, they are plastic. You can get them at harbor freight (etc). Slowly work the seal from the glass all the way around. The factory use a primitive form of buele, so be careful and slowly work that all the way around.

Here you go, takes three people. One will get in the cargo area in the middle of window toward the front. Second two each on one side where the window curves. GENTLY, have the person inside push up as you use your non-marring chisel to get underneath the gasket, this should be easy enough once you have separation each person uses chisel from center outboard, then you should be able to lift up and let the inside person go to the back and support back as outside people lift from front to back until glass is separated from gasket.

Thats how I did it. To install reverse except get some Buetel and use it but watch out its very messy, painters tape is your friend.