Head bolts broke through?

I just installed my 360 indy/IMM heads with the ARP bolts supplied by Brian . I used the mr g 1121 gasket . No decking of the block or heads. I used the arp lube that came with the bolts and toured in three steps. I was on the 100ft pounds ( and in the final turns) and felt like a couple of the bolts broke through they were tight then a little slack then down to tourque. I read threads on here about using thread sealers on them but I checked all holes and the were blind and opted to follow the arp directions and used there lube on the threads. My question is can I take out the bolts and add tread sealer to them and retourqe? Or is everything junk and I have to start over?
Thanks Chris