71valiant
Make fast, break, repeat.
Would you mind taking a few pics and posting. I'm really needing specifics on the control arm brackets. Exactly where I'm needing to drill for them. Very much appreciate it.
Anyone with a 73-76 Hellwig front sway bar.
- Thread starter 71valiant
- Start date
-
JAG_mopar
Well-Known Member
check their website for instructions to download
As I understand it, there's no drilling necessary on their front sway bars. The brackets that support the bar are bolted into existing holes on the K member.
71valiant
Make fast, break, repeat.
The 73-76 require drilling. I'm just needing a pic of the control arm where they have it drilled. Just to make sure I place it right. I have the directions, but its a close up of the area.
Yes the 73-76 LCA's have to be drilled for the LCA mounts if they don't have them from the factory.
I have that bar, but I don't think my car will be any help, my LCA's have the factory brackets.
73SwingerBuild
Well-Known Member
I have a picture on page 2 of my build thread that shows where I mounted mine. I chose to weld instead of drilling because why not.
Hope it helps.
Hope it helps.
71valiant
Make fast, break, repeat.
On the instructions, its showing to drill low on the arm, but everywhere else I see, its up higher.
-
