360 budget build questions.

yes folks its another, what to do-build 360 thread.

Car, 1971 Dart swinger.

I have a tired 318, MSD 6AL, Headman longtubes into 2 1/2" dual exhaust to the bumber ( no cross over), Wyand +plus dual plane manifold toped by a Holley DP 650 (4150).

904 w 7.25' @2.73 rear gear.

I live at 6,250' alt. but would like to drive the car to sea level.

My 360 that im building is worse than I thought, Surprise!!!
Rod journal 1-2 is smoked, rods 1-2 are beat to shiza on the big end.
Rods 1-3-2 are tight on the wrist pin, so im thinking....

Regrind crank from napa. 250.oo
3 new rods 35-40.00
ballance rods at home.
shot peen rods 20.00
hot tank block 40.00
pressure test block 80.00
cam bearings, core shift check, deck check ?

The cam im looking at is Comp XE268H, or summit part number, CCA-SK20-223-3. (230.oo)

My stock pistions look good, but...
What are your folks thoughts on some "rebuilder" 10, 10.5-1 "OEM" pistions?
remember my alt.

I figure with some quality bearings and rings that package should get me a decent short block for @ 1,000 bucks?....

All thoughts and ideas are welcome.
Thanks for the time and advice.