Eddy Pro Flo 2 EFI

I got my system installed and running. Install went extremely smooth. Edelbrock put a nice kit together. I had to figure out the throttle cable and kick down. I ended up buying 2 go cart throttle cables and modifying them to fit. That worked like a charm. I don't think I'm getting full throttle opening, so I'll have to spend some time figuring out the pedal mechanism. For the fuel tank sending unit I bought a unit with a return port in it. The only other issue I had was finding and fitting up an air cleaner.
I had two self inflicted wounds during the install; the first was measure three time and cut once. I did not do this and used a 1-1/2" conduit knock out punch to put the 1-1/2" hole in my firewall for the wire loom. I ended up with a 2" hole and a sour stomach - stupid stupid stupid! Oh well, I had to find a grommet to take care of the large hole until I redo the car. The other could have turned out far worse, I had some repair work on the floor that I should have been more cautious with. I welded a patch over one of my fuellines. I caught it before any real damage, but it weakened the fuel line to the point of rupture on the fifth start. I had to replace some of the line. Thank God I didn't end up with an insurance claim.
I went through the instructions and made sure everything was ready for first fire. That 440 roared to life on the first attempt and ran like a champ. I would recommend the kit to anyone. Edelbrock did a nice job putting this together.
Andy