Turbine Inspired Center Console DIY

I got the second layer of aluminum banding on the turbine and then added some chrome striping. You'd think I knew what I was doing the whole time... but I didnt...



I still need to work out a way to attach it to the final assembly.

I finished the body work finally, and laid down some color. I did the silver and white today since I could seperate them without taping over wet paint. I did three light coats of each respective color, then in about 50 minutes put two light coats of crystal clear over each as the can instructed. It came out well. Basically after this, the superstructure, trim and skirting get painted black. It turns out I got Semi-Gloss, not gloss, but i think that will work out because nothing else in the car is gloss, it's all Semi or satin.



I taped off the rest of the primer so it would still allow the black to adhere well and I wasn't just spraying over a clear coat.



It's going ok. Hopefully i got the paint laid down well and the tape tomorrow doesn't just peel it back off. I hate when that happens...