Installing RMS 3 inch inboard boxes

QuintinMotorCompany · Apr 22, 2015

My car is coming back from the body shop and we need to do my spring relocation kit... a couple questions... How do we know if everything is at the right angle it should be and everything is squared away. ?

Any tips or suggestions before we start digging in? Thanks a lot.. :burnout:

bOb shingler · Apr 23, 2015

what you will be doing is leaving the outside portion of the frame and cutting out the inside and back out. leave the stock bracket on to measure off of. you can drill a hole using it as a guide to help keep everything lined up also.

Matto · Apr 23, 2015

The only problem with leaving the outside portion of the frame is that the RMS boxes have 4 mounting holes, so you will have to drill those holes out of the existing frame. The other option is to cut out both sides of the frame. Here's a good rundown. http://www.bigblockdart.com/techpages/springs.shtml

roccodart440 · Apr 24, 2015

Measure but you'll see everything is pretty straight forward as to were they need to go.

davescuda · Apr 24, 2015

I did this to my 68 Barracuda. I cut both sides of the frame. If I was going to do this again I would leave the out side frame. I with I had a better pictures

bOb shingler · Apr 24, 2015

not in the correct order.

Installing RMS 3 inch inboard boxes

QuintinMotorCompany

FABO Gold Member

bOb shingler

Well-Known Member

Matto

Well-Known Member

roccodart440

Well-Known Member

davescuda

FABO Gold Member

Attachments

bOb shingler

Well-Known Member

Attachments