360 build ????s

The machine work was going to cost $590. The setup that is .040 was all one at one time. He bought a Duster with the motor in it. He seen it run a 12.03. He pulled the motor just to paint it. Pulled the heads off to see how things looked the number 6 wrist pin came out and scored the piston. Lucky on the sellers part it didn't hooch IMO. Anyway, that one cylinder needs a sleeve($175). The rods resized($80) and new bolts (he recommends). The crank is already -.010 and looks good but he isn't for sure($125 if needs ground). Cam bearings look good also($35 if needed and the Mopar block doesn't give problems). He is a buddy and knows more than I do by far. So I trust him. He also said I can take it to a machine shop and ask them questions in person with he parts right there to get verification of what needs done. That is what the $250 gets me.