65 Dart Wagon Conversion to a Sedan Delivery

The hood, grille and front valance were removed prior to pushing the wagon in the garage. I had previously sent the dented valance that was on the wagon (plus another valance) to another member who had no valance at all.



Here are some shots showing the engine compartment - it'll definitely need media blasting and some repair work on the driver's inner fender below the battery area.

The firewall. If I add factory AC, the time to do all the mods is now! Decisions! Decisions!





and
Driver's side inner fender


With the area below the battery tray. There are a few extra holes on the horizontal part of the inner fender that I will need to close (not shown)


and the passenger side inner fender


I also ran into a minor issue; I needed to swap a rear tire that just will not hold air. No problem with 4 of the lug nuts and of course the last one just spinned. Time to break out the cut-off wheel. A short time later the wheel is changed. Side note: the driver's front and rear side had previously been changed to all RH.