Can I rebuild my 8 3/4" myself?

Just finished my first one. I rebuilt everything from the BBP conversion kit ( from Dr Diff) to the sure grip itself. All bearings, new Richmond gears, axels. Etc. Everyone on here will very useful and eager to help out . You do need a press, micrometer, trq wrench , inch lb wrench for pinion bearing preload and other than that it's just knowledge and lots of that you can get from everyone here. I actually enjoyed doing mine and will never pay anyone to ever do it again, as a matter of fact after a few more of my own and ill do it for anyone else. It was also handy to build a holder that you can bolt the member in and attach it to a vise to spin it around and work on it..and a wrench to bolt on your pinion yoke to trq the pinion down to spec or crush your sleeve. There are a lot of good videos on you tube that will give you a good base line to start. just take your time , remember that some stuff is L.H thread in there . ( sure grip housing and crown gear) . Do er up. you won't disappoint yourself