Part 3 newbie

Pertronix sells a coil called the ignitor 3. Its primary coil winding is about what the stock GM HEI E coil is at .3 ohms. It is a metal cylindrical coil and looks like stock.

Get a mr gasket recurve spring kit. You only need to use one spring from the kit, and the lighter spring of the original 2 weight springs. This is the street setup and will bring in full mechanical advance a bit quicker than stock. Making it a bit snappier. The mr gasket advance weight spring recurve kit is about $11. The new nylon gear with thrust washer and roll pin should set you back about $10. A new o ring for the dizzy about 50 cents.

Nice thing is a mopar electronic dizzy uses same cap n rotor as points.

Send me a PM with your email addy, and i will snap a pic of my homemade schematic on how to wire in a 4 pin GM module. It needs to be mounted to a heat sink with white heat conductive grease. Most guys mount em to their inner fender.

When you mod the car with a GM HEI module, you remove the ballast resistor from the firewall, and connect the ballast resistor wires together bypassing the resistor.

The wiring mod is so easy, the hardest thing will be rebuilding the electronic dizzy, and timing it.